Tired of your feeder contents rotting from moisture that can’t escape? We have a solution for that.
Our feeder vent is printed from UV-resistant material that has proven durable over the past two years in the field, 24/7, through southern summers and midwestern winters. It comes with two gaskets, one for each side of the lid to prevent rain, snow, etc. from seeping into the feeder. The end is vented to allow moisture to escape but small enough to keep bugs from getting in. This was designed based on the 10-degree slope of a Moultrie feeder top but will fit any lid that you can drill a hole in.
The threads are 1-13tpi with interruptions. These are for quick attachment: simply line up the slots, push the nut up close and then twist until tight. You’ll need to drill a 1-inch hole in the top of your feeder lid.
Tired of your feeder contents rotting from moisture that can’t escape? We have a solution for that.
Our feeder vent is printed from UV-resistant material that has proven durable over the past two years in the field, 24/7, through southern summers and midwestern winters. It comes with two gaskets, one for each side of the lid to prevent rain, snow, etc. from seeping into the feeder. The end is vented to allow moisture to escape but small enough to keep bugs from getting in. This was designed based on the 10-degree slope of a Moultrie feeder top but will fit any lid that you can drill a hole in.
The threads are 1-13tpi with interruptions. These are for quick attachment: simply line up the slots, push the nut up close and then twist until tight. You’ll need to drill a 1-inch hole in the top of your feeder lid.